Design Update

Posted by on

Last round of tweaks! At least I hope it is the last round. The great thing about having a 3D Printer in your basement is the ability to quickly print your latest design out and run it thru all the test. 

The tweak didn't effect anything functional, just need to adjust the position of the round increments to coincide with the rounds when they are up against the inserted magazine. As you can see in the picture below, they line up when up against the round pusher block but the most effective way to load a magazine is to have them pushed near the magazine feed ramp.

Very minor and thus not effecting the timeline.

compact magazine loader

← Older Post Newer Post →



Leave a comment